SunYuan DIN 1X1 ISOEM (LED1) series intelligent isolation transmitter is a display and control transmitter that isolates and amplifies analog voltage or current signals and converts them into display and control transmitters with matching accuracy and linearity. The product integrates isolation, display, alarm control and transmission, and contains a set of high-efficiency multi-isolated DC/DC power conversion circuits, signal modulation and demodulation circuits, signal coupling and isolation conversion circuits, display and alarm control circuits. Especially suitable for: 0-75mV/0-5V/0-10V/0-1mA/0-20mA/4-20mA and other analog quantities free of regulation, isolation and amplification transmission, display and control. The product adopts the low-cost program of magneto-electric coupling, mainly used in the occasions without special requirements for EMC (electromagnetic interference). The internal integration process structure and new technology isolation measures enable the device to achieve: auxiliary power supply, signal input and output 3000VDC triple isolation. And can meet the industrial grade wide temperature, humidity, vibration environment requirements. Intelligent design of the new isolation transmitter series products built-in reverse connection, overload, anti-surge and other protection circuits, without the need for external components, free of zero gain adjustment, the use of standard DIN35 rail mounting, convenient for users to use the site.

       The DIN 1X1 ISOEM (LED1) series products are intelligently designed with a variety of functions not available in conventional products. With a single power supply, the analog signals can be isolated and transmitted, and displayed in decimal digital quantities according to the set range in linear correspondence. The traditional embedded analog display meter adopts potentiometer adjustment, which has a single adjustment parameter, is not flexible and is greatly affected by temperature. Compared with the traditional analog display meter, this intelligent digital display meter is operated by a combination of two buttons and controlled by the CPU of the central processor, which can realize the setting of various parameters such as zero point, full scale, decimal point, alarm, time delay, etc., and it has strong flexibility and practicability. The digital display meter adopts LED display board and has reverse and over-current protection function. The products are widely used in industrial control, petrochemical, environmental protection, smart home, mining and other industries for temperature, pressure, displacement, flow, liquid level and other physical quantities of control point monitoring.

DIN 1X1 ISOEM (LED1) series of active intelligent isolation transmitter can be directly isolated analog amplification conversion, at the same time with signal display and output alarm control function. The embedded intelligent digital display meter is used to measure the transmission signal, the displayed figure is not the direct output voltage or current measurement value, but the signal preset value, through the setting of the measured output zero and fullness of the voltage or current value relative to the two preset values are linearly displayed.  For example, if the variable output 4-20mA, 4mA is set to 0 and 20mA is set to 8000, then the meter will display 2000 when inputting 8mA and 4000 when inputting 12mA; and if 4mA is set to 1000 and 20mA is set to -1000, the meter will display 0 when inputting 12mA and -500 when inputting 16mA. The maximum display range of the digital display meter is 9999, i.e. four digits, and the minimum is -1999. It has the alarm function with two isolated switching outputs, which can be displayed, controlled and alarmed locally. The two set alarm points have positive and negative alarm direction settings. Alarm point of the alarm object for the display readings, alarm LED panel last decimal point flashes, alarm information through the digital optocoupler isolated output alarm signal. The upper limit or lower limit alarm value and alarm mode can be modified by the programmer for the products that need to set alarm function, please refer to the "Display Meter User Manual" on the back page for detailed setting method.  

Note: The alarm signal is OC gate (open collector) output, please refer to the [Alarm Output and Application] instruction on the following page for the specific application method.